- This topic has 4 replies, 2 voices, and was last updated 19 years, 2 months ago by
.
-
Posts
-
Happy new year by the way to all, not been on the site since the new year.
I’m after the part number for a pecker cable for a Hotp WM11P serial 32903672. Went to it today to fit new brushes but customer took motor out and snapped the cable!!. If I remember there a few different pecker configuarations – 3 different ones on some models but not too sure on WM11
No joy with a search.
Thanks in advance – Steve 😀
Re: Pecker cable for WM11
Mk I – outboard, metal plate – 168994 (Black)
Mk II – outboard, pivot mount – 169344 (Grey)
Mk III – inboard, pivot mount – 1601696 (Blue)Take your pick……….
Chris.
Re: Pecker cable for WM11
Chris,
Not too sure, do the colours revert to the cable itselft???
I only ask because this one sounds like it was out board pivot mount:???
ie the pecker is to the side of the motor (pivot at about 3 oclock position when viewed from the back, pivots towards the motors shaft and is almost horizontal) but I’m sure the cable was blue??
The pecker was definately not on the motor shaft itselft.
????I’m off to bed I’ll look at it tomorrow when I get 5 mins.
Tks 4 ur help
Steve
Re: Pecker cable for WM11
RocketMan wrote:Not too sure, do the colours revert to the cable itselft???
Yes – outboard related to the ones that battered themselves to pieces on the casing, the last one was “inboard” over the drum and didn’t ride on the belt, rather the motor pulley itself.
Chris.
- You must be logged in to reply to this topic.