Indesit IDL500 – Error Lights

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Indesit IDL500 – Error Lights

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 17, 2007 at 8:57 pm #24235
    Indesitproblem
    Participant

    I purchased the above model from B&Q about 13 months ago.
    The machine has performed well (despite the pink cutlery basket) until last week.
    The 2nd and 3rd indicator lights have started flashing shortly after the inital waste water pump cycle. The manual states this is due to low mains water pressure. The cold water pressure is high out of the taps and nobody has altered the tap at the rear of the dishwasher.
    I have unplugged, waited 20 seconds and tried again with the same results. I have also thoughly cleaned the drain filters.
    Any thoughts? Is this a simple problem? How much do you think it will cost to fix.
    Thanks in advance for any advice.

    MB

    January 17, 2007 at 9:50 pm #201221
    Fairdeal
    Participant

    Re: Indesit IDL500 – Error Lights

    Try to put water manually(by opening the door and with a buckett etc)just after it stops draining and see if the wash motor kicks in.we will then have better idea on what could it be

    Regards

    January 18, 2007 at 1:07 pm #201222
    Indesitproblem
    Participant

    Re: Indesit IDL500 – Error Lights

    ok, thanks. I’ll try. MB

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.