LG GRL207TUJA

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › LG GRL207TUJA

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 30, 2007 at 8:43 pm #24637
    Alanj
    Participant

    Hi Guys,

    according to customer the m/c is not making ice cubes only crushed ice.
    Anyone come across this before and what’s the cure?

    Alan

    January 30, 2007 at 8:55 pm #202815
    Kirk
    Participant

    Re: LG GRL207TUJA

    Yes the ones I have done have been the solenoid that pulls the cutter up both times it had fallen off the 2 screws had come out that hold it in place.

    Kirk

    January 30, 2007 at 9:05 pm #202816
    Alanj
    Participant

    Re: LG GRL207TUJA

    Hi Kirk,

    I’ll check that out first tomorrow, I think I’ve had that problem once before. Thanks again for the reply.

    Alan

    January 31, 2007 at 4:37 pm #202817
    expertcat
    Participant

    i have had the same fault on a few that i have been to.

    I think there could be a design problem.

    January 31, 2007 at 7:08 pm #202818
    Alanj
    Participant

    Re: LG GRL207TUJA

    Hi Guys,

    It wasn’t the solenoid, it was the bar that opens the flap which either allows ice cubes through or crushed ice. There’s a couple of crimped bits on the bar which are supposed to fit either side of a metal clip and stops the bar from moving to and fro. Because the bar wasn’t seated between these crimps, the end of the bar was snagging at the flap end.

    Alan

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.