- This topic has 0 replies, 1 voice, and was last updated 19 years, 2 months ago by
.
-
Posts
-
HELLO all once again (yes searched but could not find)!!!
Sorry no serial number as house looked like it had been occupied by squatters!!!! appliance only 18 months old apparently but looked like 15 !!!!anyway went to this appliance last week and LEDs 1 & 3 flashing. WIDL error codes say f10 pressure switch not sensing. Did I use correct error codes? Cleared hydraulics and tested contact resistances…..were a bit high so put in new pressure switch only £5….been ok for few days but need to go back on Monday as customer says same fault? I remember something about pressre switch hose needing shortening? am I remembering this correctly? Am I barking up the wrong tree…LOL or am I just BARKING????
Also any way we can have section similar to Known error codes but on known faults and tricks of the trade i.e cable ties on WMA pulley, bosch float chamber-sump hose thingy block? I realise some guys wont want to divulge…..but im sure it will be a useful resource. And may stop repetitive questions….
Cheers for helo Spuddy[/code]
- You must be logged in to reply to this topic.