Diplomat ADP 8132 – Help Needed

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP 8132 – Help Needed

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 3, 2007 at 12:25 am #24727
    Pecker30
    Participant

    Hi – I’ve used this site with great success in the past (Faulty lock on my ADP 8132 dishwasher)
    I wondered if anyone could help with this fault, my power supply tripped while the same dishwasher was running & its not worked properly since.
    I’ve reset it & it now runs the program cycle but the water doesn’t seem to spray at all (water is turned on & some does go into the bottom)
    I wondered if it could be the Programme Board or Pump????
    Any help would be very appreciated

    Many thanks
    Clive

    February 3, 2007 at 12:54 am #203098
    Penguin45
    Participant

    Re: Diplomat ADP 8132 – Help Needed

    Almost certainly the circulation pump failed, especially if water is leaking into the undertray. You will obviously have to inspect to be sure……… Be safe, pull the plug.

    Pump is p/no 695210296 – about £110 from memory. An email to spares@ukwhitegoods.co.uk for confirmed pricing and ordering of you wish to proceed.

    Regards,
    Penguin45.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.