Hotpoint CTD 80 condenser dryer f10

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint CTD 80 condenser dryer f10

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 4, 2007 at 10:28 am #24754
    Simon46
    Participant

    Going to this one tomorow. Cust said that the dryer got hotter before it failed completely even hot after the cool down cycle (stuck relay?). Condenser cleaning and filter has been carried out regularly.Should the heater/stats be upgraded to the latest type and should the module and eeprom be replaced? and what is the latest version?

    Regards
    Simon

    February 4, 2007 at 6:54 pm #203203
    helo_75
    Participant

    Re: Hotpoint CTD 80 condenser dryer f10

    if it got hotter than normal, itll just be the stat.. fit a heater assy, itll be fine

    February 5, 2007 at 9:59 pm #203204
    Simon46
    Participant

    Re: Hotpoint CTD 80 condenser dryer f10

    Ok seen this one and one shot is blown. Thermistor rear reading 34.7K front is 83.8K (Cool room). supplier says heater assy now has 3 stats. Is this correct?

    Regards
    S.

    February 5, 2007 at 10:02 pm #203205
    helo_75
    Participant

    Re: Hotpoint CTD 80 condenser dryer f10

    yup

    if its a pcb controlled machine, yes it should have 3


    would probably be best to change the whole heater assy

    February 5, 2007 at 10:13 pm #203206
    Simon46
    Participant

    Re: Hotpoint CTD 80 condenser dryer f10

    yes thanks for info helo. serial number by the way is 510200554.

    S.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.