Hotpoint W/M PCB Part no required.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Hotpoint W/M PCB Part no required.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 6, 2007 at 7:05 pm #24827
    grooster
    Participant

    Hi,

    I’ve just been out to a Hotpoint washer, WF210T – 41111298 – and the front pcb panel has gone. The start switch has dropped off. Tried to solder but to no avail.

    Just been on the hotpoint website to look for the price and noticed its a different panel to the one listed on Masterparts for the same model.
    Masterparts says 1604899 £71.00. If i put that part number in Hotpoint it comes out at £90 ish. But if i put the model number in on the hotpoint site and it comes up with a panel at £75.00. Which is right.

    Can anybody give me the right part number for this machine.

    Cheers

    Nick

    February 6, 2007 at 9:41 pm #203419
    mutley
    Participant

    Re: Hotpoint W/M PCB Part no required.

    Should be 1604899- as that has prog selector plus 2 others probably variable temp and spin speed

    February 6, 2007 at 10:28 pm #203420
    grooster
    Participant

    Re: Hotpoint W/M PCB Part no required.

    No this only has a programmer and a spin speed dial. Just the two knobs.

    February 6, 2007 at 11:00 pm #203421
    iadom
    Moderator

    Re: Hotpoint W/M PCB Part no required.

    Partfinder only lists 1604719 for that model but it has a picture link to that part number. That shows three different PCB’s, 1 knob, 2 knob & 3 knob. The 2 knob PCB is listed as 1604719.

    1 knob as 1604722.
    3 knob as 1604099.

    Masterpart have it listed at almost £90 + vat but Partfinder lists it as around £61 + vat. 😕
    Spareslink is much nearer the mark. 😉

    Jim.

    February 7, 2007 at 8:24 am #203422
    grooster
    Participant

    Re: Hotpoint W/M PCB Part no required.

    Thanks for that Jim. Thats the one, 1604719. Its amazing that Masterparts are actually selling them at more than the Hotpoint Public website.
    I dont have an account with Qualtex – (spareslink) but have just sent off for details this week anyway.

    Thanks for your help

    Nick

    February 7, 2007 at 9:44 am #203423
    iadom
    Moderator

    Re: Hotpoint W/M PCB Part no required.

    Could just be an error on the web page, have a word with your rep or contact Masterpart by e-mail, they usually respond fairly quickly.

    Jim.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.