INDESIT WASHER wil 103

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › INDESIT WASHER wil 103

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • February 8, 2007 at 4:19 pm #24892
    cornflakes
    Participant

    FAULT SHOWING

    DOOR “LOCKED LIGHT RAPID FLASHING“

    ALSO “DELAY TIMER LIGHT FLASHING“

    machine will not do anything

    cant see any thing on fault codes listing for this model

    any ideas welcome

    regards

    Graham

    February 8, 2007 at 7:17 pm #203700
    iadom
    Moderator

    Re: INDESIT WASHER wil 103

    Known Error Codes thread, page #3 post by Dave Conway near the bottom, same as WIDL

    Jim.

    February 8, 2007 at 7:45 pm #203701
    WhiteVanMan1
    Participant

    Re: INDESIT WASHER wil 103

    I realise you will probably have checked this, but a seized pump causes all sorts of problems on these machines. I had one recently just the same with a good old bra wire stopping it.
    Steve

    March 6, 2007 at 5:16 pm #203702
    cornflakes
    Participant

    Re: INDESIT WASHER wil 103

    have revisted this problem client been away

    have change pump..no change to problem

    reading a recent post re similar machine, i now understand that door locked red light flashing is not part of error code readings

    so i have only 1 greenlight flashing

    machine will wash – drain and start to spin than go into fault

    also on drain only water evacuates fine..but after 4 mins goes into fault

    have been delaying this job awaiting the how clean is your house team to visit.. just pulled machine out,under the carpet is 20 year old daily mirror as underlay

    any further help appreciated

    Graham

    March 6, 2007 at 6:03 pm #203703
    iadom
    Moderator

    Re: INDESIT WASHER wil 103

    So, what number from the left is the flashing green neon?

    March 6, 2007 at 8:03 pm #203704
    admin
    Keymaster

    Re: INDESIT WASHER wil 103

    Graham,
    If its the left Led from optional button is F08 (assuming that the fascia Led’s order is like Ariston). So check termistor (sensor) & connector, heater &heater relay ( for earth leakage also). 8)

    March 6, 2007 at 8:23 pm #203705
    roy1
    Participant

    Also remove module and clean the board contacts and tighten the edge connectors by squeezing
    with pliars (can give fo8 fault even on spin).
    Roy

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.