BOSCH TIMER STICKING.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › BOSCH TIMER STICKING.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 20, 2007 at 3:13 pm #25209
    JOHN CLARKE
    Participant

    HI,
    I have a Bosch, WFF1401GB. The machine fills, tumbles, heats, moves out of the heat pause, then does a short tumble clockwise, long tumble anti-clockwise and does not move out of this phase. I think its the timer/module but i know a lot of other things control the timer. Any ideas please?
    John. 🙁 🙁

    February 20, 2007 at 3:24 pm #204899
    gegsy
    Participant

    Re: BOSCH TIMER STICKING.

    Hi
    Does it drain if you turn it to spin?

    Greg

    February 20, 2007 at 3:28 pm #204900
    JOHN CLARKE
    Participant

    Re: BOSCH TIMER STICKING.

    Hello that was quick,
    Yes it pumps out and spins.

    February 20, 2007 at 3:29 pm #204901
    Martin
    Participant

    Re: BOSCH TIMER STICKING.

    Hard to put a finger on it John but best megger the heater and motor. Brushes are likely problem and look closely at the timer/module board connecting plugs (can burn out on this model). Also check the cold double valve is not open circuit?

    That should keep you busy…. 🙂

    February 20, 2007 at 3:37 pm #204902
    JOHN CLARKE
    Participant

    Re: BOSCH TIMER STICKING.

    HI again,
    Checked the heater, meggers out OK,heats up OK, changed the brushes, looks like I’m back to the timer, they are expensive though, lot of money to lay out if its not at fault.

    February 20, 2007 at 3:39 pm #204903
    gegsy
    Participant

    Re: BOSCH TIMER STICKING.

    Hi
    First things first 🙂
    Check your email 😉

    Greg

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.