Diplomat ADP 8342

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP 8342

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 23, 2007 at 10:05 pm #25327
    whitters
    Participant

    I have a diplomat ADP8342 Integrated slimline dishwasher
    Bleeps as soon as I shut the door and first 3 lights flashing when open.
    Wont fill up

    Tried reset by pushing P button quickly 4 times but nothing happening

    Any ides?

    Thanks

    February 23, 2007 at 10:20 pm #205434
    Penguin45
    Participant

    Re: Diplomat ADP 8342

    Reset is only applicable to SMEG-built Diplomat dishwashers. Yours is the Chinese Haier slimline dishwasher.

    First three lights mean that the flood protection system has been activated – this means that the base below the machine is flooded.

    Proceed as follows – Remove plug. Drag machine out of housing. Lay plenty of towels at the back of the machine and slowly lean it back. When the flow stops, it should reset itself.

    Future use – Stop using multi-function tablets. They generate excessive foam, which this machine will not tolerate. Secondly, once the programme has started, never, ever open the door until it’s finished…….

    Apart from that, it’s a brilliant piece of kit :rolls: . If the problem recurs, bearing in mind the above comments, you may have a deeper rooted problem which will have to be investigated further.

    Good luck with it,
    Penguin45.

    February 23, 2007 at 10:25 pm #205435
    whitters
    Participant

    Re: Diplomat ADP 8342

    How do I take it out of the casing when it is intergrated?

    February 23, 2007 at 10:30 pm #205436
    Penguin45
    Participant

    Re: Diplomat ADP 8342

    Well, normally the kick board’s got to go, couple of retaining screws round the top somewhere to undo and it should all slide forward. It’s your kitchen, you’ll have to work it out! 😀

    Penguin45.

    November 13, 2020 at 7:28 pm #205437
    s wang
    Participant

    [h=2]Diplomat ADP 8342, turn power on, just power light on, no any program lights on, washer on work. tryed “4 times reset” nothing! hope guys give me advise. many thanks ahead.[/h]

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.