- This topic has 4 replies, 2 voices, and was last updated 19 years, 1 month ago by
.
-
Posts
-
I received this machine stuck on TEST regime (also display shows that). He carry out Test and stops, but as soon as touch any key he starts again. I do know that to get in test you need Diagnose Key (hardware Key). So I do not know how to get out from there only with user interface (board).
Has any info about? ( I have seen before one post where someone said he know about that, but I cann’t find that post)
Thanks,
Baron 8)Re: EvoII Indesit WIE107
Hi Baron, how is Romania this fine morning?
You could try some of these methods, it may be similar to Hotpoint based machine controls. Sometimes you need two or three attempts to clear tESt.
The problem is caused by the customer pressing both ON/OFF and START/CANCEL buttons at the same time.
Jim.
Re: EvoII Indesit WIE107
Jim, it’s best starting with good black coffee. :70s:
I did try but nothing (shows “dOFF” and still after “tESt”). :conf:
I have change PCB and try to see what’s happen when you press “start”&”power” together= “dON” and after shows “dENO” not “tESt”. So it’s clear that it is another thing. :colour:
I will wait for “Diagnose Key†(Hardware Key Serial) in this weekend in order to investigate forward. I will keep you inform when I have some results.
Baron 8)Re: EvoII Indesit WIE107
Unfortunately that model number does not come up on UK based parts identification software.
Hopefully one of the helpful Indesit engineers may know the UK equivalent and its reset procedure.
😉
Jim
- You must be logged in to reply to this topic.