askoll

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › askoll

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 11, 2007 at 8:18 pm #25766
    superspin
    Participant

    hi all

    could anyone tell me if this part no5031680945362 is a correct replacment motor for a
    whirlpool dishwasher ADG755
    The original is a askoll and the picture of the motor is different,as this job is a distance away i need to now it will fit.

    thanks for any advice..

    March 11, 2007 at 8:23 pm #207516
    bobokines
    Participant

    Re: askoll

    Yep.. That’s the correct bit. The askoll pump is now replaced by a ‘proper’ motor and pump.

    Worth taking a new jubilee clip with you as a special tool is required to fit the supplied clip 🙁

    Bob

    Edit…

    I carry a few WPL481940118174 clips as van stock

    Very useful clips

    Bob

    March 13, 2007 at 10:13 pm #207517
    roly16
    Participant

    Re: askoll

    bobokines wrote:
    Worth taking a new jubilee clip with you as a special tool is required to fit the supplied clip 🙁
    Bob
    Edit…
    I carry a few WPL481940118174 clips as van stock

    Very useful clips

    Bob

    Just looked those up on Connections. At £3.10 a clip they jolly well should be useful 😯 . I usually open up the old clips with a flat screwdriver and re-crimp them with pincers. Works nearly every time unless the ratchet comes apart. Think i may get one or two of the £3.10 ones though just in case….

    March 13, 2007 at 11:00 pm #207518
    bobokines
    Participant

    Re: askoll

    Oh! I make sure the customer pays for the part 😉

    There are other sources for this size clip and it has been voiced here before. But they do for me.

    Bob

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.