Indesit DI620 D/washer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit DI620 D/washer

  • This topic has 7 replies, 5 voices, and was last updated 19 years ago by PGS.
Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • March 16, 2007 at 8:37 am #25882
    PGS
    Participant

    Called to above yesterday customer saying set m/c and filled and washed then stopped after approx 40 mins and led 4 lit. When i set m/c same happened but led 3 lit. The dispenser did not open and i checked voltage to heater @ 0 volts, when i removed tags from heater i had 240v and 30 ohms resistance across heater , when replaced tags 0v. Pressure system ok. Any ideas where to go nxt possible pcb? cheers Paul.

    March 16, 2007 at 5:52 pm #207953
    effzedarr
    Participant

    Re: Indesit DI620 D/washer

    Bad earth on heater? Worth checking had similar on H/point dwf 40.
    Chris..

    March 22, 2007 at 1:45 pm #207954
    PGS
    Participant

    Re: Indesit DI620 D/washer

    The saga continues I fitted a heater to this m/c and the same fault is present, although the dispenser fault is resolved ( customer forced shut after inserting tablet) Do i order PCB ,.

    March 22, 2007 at 1:50 pm #207955
    Martin
    Participant

    Re: Indesit DI620 D/washer

    Probably the relay on the board is at fault then = new board.

    March 22, 2007 at 4:22 pm #207956
    admin
    Keymaster

    PGS,
    Question: heats or not sensing temperature arising?

    March 22, 2007 at 10:00 pm #207957
    PGS
    Participant

    Re: Indesit DI620 D/washer

    No heat at all

    March 22, 2007 at 10:35 pm #207958
    hotpnt
    Participant

    Re: Indesit DI620 D/washer

    hi, if you try to start a prog with the heater disconnected it should go straight into a fault mode sensing that the heater is OC, if it does not then this will prove a fault on the module,

    March 31, 2007 at 5:35 pm #207959
    PGS
    Participant

    Re: Indesit DI620 D/washer

    UPDATE– Replaced module m/c now A1 thanks again Paul.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.