- This topic has 2 replies, 2 voices, and was last updated 19 years ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Going out ot this on Thursday. Customer reports machine ended cycle normally but was beeping away.
Tried next time, Start neon is flashing and after a short while it starts beeping but does nothing else.
Could this be a flooded base due to pump failure?
Jim.
Re: Whirlpool D/W ADG 7952
if you count the flashes before it pauses, you can tell what is wrong. if there is no pause it is an f1= ntc failure
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.