Zanussi ZWF1621

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWF1621

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 1, 2007 at 11:16 am #27042
    bigkid
    Participant

    Just been to the above and these are the symptoms.
    Fills ok then only ‘occasional’ motor action.
    Put on spin, pumps ok when empty tumbles for about 5 seconds then dead.
    Something is aborting the prog I guess, any clues?
    Prime suspect has to be PCB, am I right in saying these are preconfigured.
    regards
    Tony

    May 1, 2007 at 11:46 am #212393
    Bryan
    Participant

    Re: Zanussi ZWF1621

    Hi Tony

    I’d have a good look at the carbon brushes. Had one of these recently that was upsetting the electronics due to arcing at the commutator caused by brushes being very low.

    HTH

    Bryan

    May 1, 2007 at 12:04 pm #212394
    bigkid
    Participant

    Re: Zanussi ZWF1621

    Thanks for that Bryan, the machine is literaly 2 weeks out of warrenty, I ‘looked’ at the com when the drum was turning and it ‘seemed’ ok although didnt take out the carbons.

    Tony

    May 1, 2007 at 12:18 pm #212395
    Mac1982
    Participant

    Re: Zanussi ZWF1621

    If its only 2 weeks OOW, it may be worth contacting the manufacturer if you havent done so already to see if they can do anything….I know most of them are quite flexible with offering repairs to units that are upto 4 weeks OOW…Well from my experiences anyway. Hope this is some help. 😀

    May 1, 2007 at 12:21 pm #212396
    bigkid
    Participant

    Re: Zanussi ZWF1621

    Ta Mac, it might come to that but loose a job? goes against the grain .. :rolls:

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.