creda t632cw condenser dryer

This topic has 6 replies, 5 voices, and was last updated 18 years, 11 months ago by tedd.

Viewing 7 posts - 1 through 7 (of 7 total)

Author

Posts
May 8, 2007 at 7:56 pm #27208

tedd
Participant

hi went to above dryer today no light coming on,there is power to the machine checked as far as door switch any suggestions regards tedd

May 8, 2007 at 10:05 pm #213070

suedehead1
Participant

Re: creda t632cw condenser dryer

just a thought is the water bottle full or not pushed in properly?
or it could be the relay.

November 28, 2007 at 8:29 pm #213071

neilsukwg
Participant

Re: creda t632cw condenser dryer

Ted
did you sort this one out?
Got the same problem, checked all usual door micro, start button etc.

No obvios damage to pcb?

Neil

November 29, 2007 at 7:18 pm #213072

timdowning
Participant

Re: creda t632cw condenser dryer

Had same fault on similar model the other week. Changed dryness module and it all sprang back to life!

November 30, 2007 at 6:17 pm #213073

Bernie
Participant

Re: creda t632cw condenser dryer

I have had same fault on Creda condenser dryer it was the micro switch that tells you when the water bottle need emptying, the little arm on the switch gets stuck up if you take the right side panel of, the switch is just behind the motor you can just get to the arm with a long screwdriver and release it.
Hope this helps
Bernie

November 30, 2007 at 6:30 pm #213074

neilsukwg
Participant

Re: creda t632cw condenser dryer

Thanks

Going back tomorrow armed with latest info.

Regards
Neil

December 1, 2007 at 5:50 pm #213075

neilsukwg
Participant

Re: creda t632cw condenser dryer

Turned out to be the push switch (start) on this one.
It was on its way out, working with a good hard push but only just.
In stock at my local spares shop, job jobbed!
Author

Posts

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.