- This topic has 1 reply, 2 voices, and was last updated 18 years, 10 months ago by
.
-
Posts
-
Hi guys
after about two minutes of washng all the prog lights flash and it beeps ,I asssume it’s a fault code but what it is I don’t know .
does anyone have a procedure to interrogate the machine on a PDF ?
Here’s hoping
Lawrence
if you have – L.carey4@NTLworld.comRe: Miele G1180vI
G1180 will try to start circulation motor 10 times after it fills with water & if pressure is not sensed it will abort programme.
I presume this is whats happening.
You will need to check circulation motor to see if its seized up.
Remove base of machine, 2screws at front under plinth & 2 screws on base near back , remove bracket screw on lower back panel mounting motor. Remove hoses & unclip pressure switch & wiring. Motor should ease out. Take heater plate off pump & you should then see if theres an obstruction fouling the impellor.
Sometimes these seize up if they haven’t been used for a while & you may find that it just needs a sharp turn to release.
- You must be logged in to reply to this topic.