- This topic has 9 replies, 5 voices, and was last updated 18 years, 10 months ago by
.
-
Posts
-
hi guys have to go look at a zanussi washing machine mode fls 1183w the problum is it does not matter what program it is put on skip throught at a fast pace filling empying spinning any pointers thanks fasetester 😕
Re: zanussi fls 1183w
thanks martin would that be the pump and filter blocked nothing else can the manofold be cleaned by removing the hoses or does the whole unit have to be removed with the filter houseing and pump fasetester
Re: zanussi fls 1183w
thanks rouge element is that the clip that holds magnet on the shaft of the motor do the come loose would that cause it to skip right to the end of the program just filling breifly then pumping then spinning breifly as if the whol program is speeded up and stopping at the end .fasetester 😕
Re: zanussi fls 1183w
Check the magnet is not loose as some times the magnet unscrews and dosn’t always show itself buy pushing tacho cover off.. this will cause symptoms you describe and I have had a few do this..
Worth a try before anything else as elecronics sense the speed is wrong and pushes it through the program.. main indicator is that the first time it fills on wash the motor trys to go into spin speed instead of wash speed then impulses through the rest of the program..
Other than that I would check out tacho circuits for o/c or earth fault
Mick
Re: zanussi fls 1183w
short circuit ntc can also cause program to rapidly advance also worth a check
thanks mick if there was an earth fault would the machine not trip out the circuit breaker what would be the most likely thng to cause a leakage heater or motor ect thanks comptonappliances how do test the ntc and where is it situated on this machine thanks for all your replys
Re: zanussi fls 1183w
ntc in back by the heater check resistance i.e not down to earth/ and also measure resistance if 0 it is short circuit would normally be abot 500 ohms depending on temperature
- You must be logged in to reply to this topic.