- This topic has 4 replies, 5 voices, and was last updated 18 years, 10 months ago by
.
-
Posts
-
Hello, I have a customer with a hotpoint wf340 which aborts the wash then the mini load and rinse hold lights flash. Obviously the fault code but does anyone know what the fault codes are for these machines 😕 .
Cheers
Re: Hotpoint WF340 – aborting wash…
Are you sure it is a 340? cannot see a Mini Load button on WF340. May be a WF350 or WF430.
However, you should always ask your customers to give you the flashing neons by number from top down. On machines that do have a Mini Load button together with Rinse Hold, that would be neons 1+3. Using the information in the Known Error codes thread would reveal an F10 fault. Pressure switch not sensing: Check switch & module connections.
Codes for these machines can be found on page 4, post 5 of the Error codes thread.Jim.
Re: Hotpoint WF340 – aborting wash…
Error Codes Thread… ???
Can you post a link to the thread Iadom please?
Re: Hotpoint WF340 – aborting wash…
Allsorts wrote:Error Codes Thread… ???
Can you post a link to the thread Iadom please?
It’s located at the top of the Trade Technical Forum for future reference. 😉
But just for you……click on the link below. 🙂
Re: Hotpoint WF340 – aborting wash…
Allsorts wrote:Error Codes Thread… ???
In this trade section marked as a sticky 😉 Known error codes
Allsorts wrote:
Can you post a link to the thread Iadom please?Will i do 😆
Don
- You must be logged in to reply to this topic.