miele

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › miele

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • June 4, 2007 at 5:06 pm #27862
    tanner
    Participant

    hi guys,
    can anyone help with this one i am going out there in the morning and though i would get some feed back first.

    miele w865 , customer has reported that they did a wash and the machine made a loud bang and jumped forwrds 4 inch’s, now all the machine do is start fill then drain straight away and it is flashing the rinse light any ideas.

    many thx
    stuart

    June 4, 2007 at 6:19 pm #215914
    msappliance
    Participant

    Re: miele

    1st rinse light is brushes or as miele call it a module, just check armature aswell. Also check motor wiring as this breaks or rubs on chassi.

    June 4, 2007 at 7:03 pm #215915
    Seamy
    Participant

    Re: miele

    Yeah, like he says likely to be worn brushes, easy peasy, take off front panel, i normally tip machine back a litle, take motor “module” (end cap)off you should then see brushes, if worn replace, clean armature.
    Careful locating pins when re-assembling.

    June 4, 2007 at 8:02 pm #215916
    tanner
    Participant

    Re: miele

    thanks guys i have never worked on a miele before so it will be a learning experiance, thanks for all your advise.


    stuart

    June 5, 2007 at 10:27 am #215917
    tanner
    Participant

    Re: miele

    hi all,
    just returned from this machine and the brushs are good, check motor wiring and continuity, check connections to main board and it still fills then drains while flashing the rinse light it seems that as soon as the motor is expected to work the rinse light flashe’s, i have gone with a main board but to be honest can’t be to sure any feed back would be good.


    stuart

    June 5, 2007 at 11:30 am #215918
    gegsy
    Participant

    Re: miele

    Hi
    I know the WS5425 used to get loom damage in the bottom right. May be worth a look 😀 The loom may read ok with panel in a different position when testing. 😕
    Greg

    June 5, 2007 at 12:14 pm #215919
    chezza
    Participant

    Re: miele

    worth also checking that it didnt go unbalanced and pinch wiring somewhere in the loom as it danced

    June 5, 2007 at 12:38 pm #215920
    tanner
    Participant

    Re: miele

    speaking to the customer she had a duvet cover in there with a load of towels after th machine tryed to go in to orbit she removed the said items from machine and found that all the towels were inside the duvet cover so the machine could not dispibute correctly.
    she said when it happened it made her run out of the kitchen it has damaged the side board it was underneath so it really must have gone for it.


    stuart

    June 11, 2007 at 4:14 pm #215921
    tanner
    Participant

    Re: miele

    hi guys turned out to be the main board ouch! all fixed now.

    stuart

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.