Diplomat ADP8332 Error code F7

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Diplomat ADP8332 Error code F7

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 6, 2007 at 5:13 pm #27926
    robertcanavan
    Participant

    Hi all,

    Could someone help? I have a doplomat ADP8332 with the error code F7. I believe this fault is a Flow meter failure. Could anyone give me any further information regarding location, part number, replacement etc?

    Thank you,

    June 6, 2007 at 8:17 pm #216117
    Penguin45
    Participant

    Re: Diplomat ADP8332 Error code F7

    Replacement not always neccessary, it’s very often just a loose or oxidised connector. Remove left hand side panel to investigate.

    Power off, of course.

    Regards,
    Penguin45.

    June 6, 2007 at 9:41 pm #216118
    robertcanavan
    Participant

    Re: Diplomat ADP8332 Error code F7

    Am I right in assuming that a Flow Meter is also known as Solenoid value? Thank you for your reply.

    June 6, 2007 at 10:05 pm #216119
    iadom
    Moderator

    Re: Diplomat ADP8332 Error code F7

    robertcanavan wrote:Am I right in assuming that a Flow Meter is also known as Solenoid value? Thank you for your reply.

    Unfortunately not, it is not even a solenoid valve 😉 Follow P45’s advice, flow meter is a small PCB attached to the large plastic fill matrix.

    Jim.

    September 27, 2007 at 7:50 pm #216120
    EBO
    Participant

    Re: Diplomat ADP8332 Error code F7

    Hi all,
    I have got the same problem but I have investigated and there does not seem to be anything wrong with the connector (the clear tube?). Is there anything particular that I should be looking for?

    If it is not the connector could it be anything else?

    Many thanks in advance.
    EBO

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.