- This topic has 3 replies, 2 voices, and was last updated 18 years, 10 months ago by
.
-
Posts
-
Hi All,
I hope someone can help. I’ve got a Firenzi DW930 (Whirlpool) and it’s stopped working. When it’s turned on it makes a noise that I’m familiar with, but then there’s no sound of gushing water or anything spinning. After about 20 seconds the start light flashes and beeps and the cycle goes no further. It doesn’t appear to be filling up with water.
This applies to both hot and cold cycles.
I have thrown some water in, but when I start the cycle this gets drained. Maybe I should try interupting the cycle and then throwing some water in?
Anyone have any tips that I can try to help identify the problem?
Any suggestions on what’s gone wrong would be really appreciated.
Best Regards,
StuRe: Please Help: Firenzi DW930 not filling or washing
What is the pattern of the flashing light (ie 1-2-3-4-pause-repeat)?
Penguin45.
Re: Please Help: Firenzi DW930 not filling or washing
Sorry but there doesn’t seem to be a pattern. The start light just flashes repeatedly while the dishwasher beeps
About 10 months ago the dishwasher was completing a cold wash, but ending early on a hot wash. With your help I replaced the water heater which resolved the problem, many thanks!
I’m sure this problem isn’t related to the heater. I have checked the part I replaced and it seems fine. Any Ideas?
Re: Please Help: Firenzi DW930 not filling or washing
OK, that’s F1 – ntc error – you need one of these:
http://shop.ukwhitegoods.co.uk/index.ph … 25_854_875It’s a twist fit from underneath – power off first.
Regards,
Penguin45.
- You must be logged in to reply to this topic.