Hotpoint wma30

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint wma30

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 18, 2007 at 9:52 am #28222
    Steven
    Participant

    Prewash light flashing, appliance not working.

    I know the fault code is in the forum somewhere, what does this code usally mean?

    Cheers
    Steven

    June 18, 2007 at 9:55 am #217413
    iadom
    Moderator

    Re: Hotpoint wma30

    Its a fill time out fault, tap turned off, duff fill valve etc. If those are OK then the PCB will be at fault.

    Jim.

    June 18, 2007 at 4:15 pm #217414
    Steven
    Participant

    Re: Hotpoint wma30

    Cheers

    After all went out found customer is in the middle of a kitchen refurb, drain hose about 6 inches off the ground runs out of cat flap round a corner straight into waste pipe.
    Dont know how it worked ok for this long.

    Steven

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.