old hotpoint d/w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › old hotpoint d/w

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 3, 2007 at 7:27 pm #28694
    hilly
    Participant

    the old 78 series hotpoint d/w could anyone help me? on the meetering tank lower right there is a hole do u have any idea why it would leak from here and what can i do to cure it? not had to do much on these.

    thanks paul

    July 3, 2007 at 7:33 pm #219608
    nationalhomecare
    Participant

    Re: old hotpoint d/w

    Assume its full size machine?……….
    Sounds like the hose from the tank to the sump is blocked (usually black rubber type) then overfills and spills out of that little hole, usually locks out the safety valve too.
    Should be an old Bosch SMS machine.
    Failing that, blocked tank.
    Steve

    July 3, 2007 at 7:59 pm #219609
    Martin
    Participant

    Re: old hotpoint d/w

    …..in addition to Steve’s reply…..Also check that the water inlet nozzle into that metering tank (at the top) is not scaled up? If it is, often the water not only enters the metering tank at a rate of knots but overflows into the tub at the same time. The result means that the machine overfills and water pours out of that “little hole” straight down over the salt valve and onto the baseplate!

    HTH?

    July 3, 2007 at 8:14 pm #219610
    hilly
    Participant

    Re: old hotpoint d/w

    thanks for replies ill give it a go it looks like its been leaking from there but sods law didnt leak when i went to it so im just waiting for the call at least ill be prepared thanks to ukw replies 😉

    thanks again 😀

    July 4, 2007 at 2:15 pm #219611
    johnnyj
    Participant

    Re: old hotpoint d/w

    If it leaks from the breather hole in the metering tank, you will prob,ly find a partial blockage in the sump hose a good clean out normaly does the trick. ps If it is this it only leaks on the third fill so it isnt easy to find.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.