- This topic has 9 replies, 4 voices, and was last updated 18 years, 9 months ago by
.
-
Posts
-
EW62G
sn. 74100025the cooling fan is not working.
the fan motor is fine, but no supply to it.
connect list’s a “cut in” stat, but i cant find one on the machine.
i presume that the phase is picked up from the output of the trigger board, do these fail very often?
if so has any one a part number?
and also i will change regulator for the grill at the same time, any one a part number for it.
thanks.
johnRe: creda cooker problems
on the right hand side behind the controls 6101453 although ther was a change made during production run
wilf
Re: creda cooker problems
hi buddy,
there is no stat behind the controls on this model as far as i can see.
do you think it could be the trigger board?
cheers.
johnRe: creda cooker problems
From memory on most Creda cookers & ovens theres a stat mounted on the top behind the controls its normally open contact, its a low temp’ cut in at approx 40-50C & runs cooling fan until temp is returned to below setpoint even after switch (for grill/top oven etc) is off.
Re: creda cooker problems
After dc 96 Novemeber 2001 Trigger board was removed and cut in stat was used, you have a dc 74 so you will require 6222118 Trigger board it is situated above mains terminal block.
Re: creda cooker problems
cheers,
any one got a wiring diagram for this model i can have a look at?
ta.
johnRe: creda cooker problems
great stuff,
thanks mate,
dont suppose you have part number for the grill regulator to hand do you?
ta.
john
- You must be logged in to reply to this topic.