Hotpoint FFA90

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint FFA90

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 23, 2007 at 9:02 am #29189
    Steven
    Participant

    Hpt ffa90 Fridge freezer, not cold in fridge, so I replaced a few weeks ago the evaporator cover and fan foam gasket as it iced up jammed fan, the silver foil etc was lifted and ice built up behind so that was the reason for replacing it.
    Now customer saying the display is showing the correct temp, could this be a sensor or pcb fault, as it doesnt show any sensors on the spares list only pcb.

    No fault code is showing and all seeems to be working.

    Any ideas

    Steven

    July 23, 2007 at 10:20 pm #222252
    bubs
    Participant

    Re: Hotpoint FFA90

    Sorry I don’t understand; all is working???

    I have a FFA91, I think unlike early FF types it shows the temp it is aiming at rather than current temp.
    Graeme

    July 24, 2007 at 9:35 am #222253
    Steven
    Participant

    Re: Hotpoint FFA90

    Sorry did not mean to confuse;
    The F/F appears to be working normally as the temperature inside is reading what the set temp in the memory is displaying(-18-20) tested this by using a thermometer to check it, however the actual display reading 10-18 degrees less.( Looks like a display fault)

    Steven

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.