DeDietrich d/w door springs

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › DeDietrich d/w door springs

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 25, 2007 at 1:23 pm #29259
    Goatboy
    Participant

    DVF120JU1/3

    Apparently these are the door springs….

    31X8407

    Yeah, small aren’t they 😕

    So Goatboy senior is refusing to go and pull the machine out (tis a big job) because he doesn’t believe that they hold the door up.

    Anybody?

    July 25, 2007 at 5:42 pm #222504
    clivejameson
    Participant

    Re: DeDietrich d/w door springs

    The last De Dietrich that i put door springs on took two of us to do the job…one to stretch the springs up to the top mounting, and the other to stop the whole machine lifting off the floor under the strain 😆
    In fact it felt like one of the most dangerous jobs i’d undertaken 😕

    They do look….well….kinda small 😆

    July 26, 2007 at 7:28 pm #222505
    wench
    Participant

    Is this proof that size matters? 😉

    July 27, 2007 at 3:26 am #222506
    admin
    Keymaster

    Re: DeDietrich d/w door springs

    Hi Goaty

    The last De Dietrich that i replaced the door springs on was no where near anything like youve got.

    They was a lenght of nylon with a plastic moulded to each end that then connectled to a spring approx 6″ then onto a open jubilee clip which was secured at the top.

    Nasty horrible job and the peices of nylon was approx £80 aas well if i remember rightly.

    Bryan

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.