Hotpoint WF 440

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WF 440

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 20, 2007 at 6:09 pm #29930
    Turbo
    Participant

    Can anyone help on this one please.
    Went to this machine today, customer vague as to what was wrong.
    So I put it on the rinse and spin program it filled up ok with correct drum action. After a couple of minutes I cancelled this program by setting it to the drain position. It then began to pump out ok but then the On/Off light started to flash along with the Mini Load light, the pump still continued to run and the only way I could stop it was to unplug the machine.
    When I plugged it back in and turned it off at the off button so no lights were showing on the facia it turned itself back on after 30 secs and the pump ran as before with the mentoined lights flashing.
    Thanks
    Graham

    August 20, 2007 at 7:17 pm #225225
    iadom
    Moderator

    Re: Hotpoint WF 440

    And the Mini load light is number ? from the top down. 😉

    Jim.

    EDIT, just dug out the manual to have a look at the very small picture.

    Unfortunately you have a case of the dreaded F08 or 8 flashes. Heater relay fault ( allegedly ) 😥

    August 20, 2007 at 9:54 pm #225226
    indespoint
    Participant

    Re: Hotpoint WF 440

    After a couple of minutes I cancelled this program by setting it to the drain position.

    You dont cancel progs by moving the dial you have to press and hold start button then reslect program you want.

    August 20, 2007 at 10:01 pm #225227
    DDSDDS
    Participant

    Re: Hotpoint WF 440

    we call it the f08 of death

    August 21, 2007 at 6:02 pm #225228
    Turbo
    Participant

    Re: Hotpoint WF 440

    Thanks for the help on this one, recon unit on its way from EMW
    Graham

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.