Hotpoint 9525 pecker

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint 9525 pecker

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • August 22, 2007 at 10:35 pm #30000
    Simon46
    Participant

    Can it be converted to inboard pecker? What is reqiured? Battering it off the motor against cabinet.

    S.

    August 22, 2007 at 10:38 pm #225475
    iadom
    Moderator

    Re: Hotpoint 9525 pecker

    Inboard pecker can only be fitted to a motor that has the threaded hole in the casing to take the pivot pin.

    Apart from the fact that any OOB load will diss the old style peckers, if it is constantly banging on the cabinet then either the suspension legs are goosed or there is a fault in the control timer or broken solder joints on the PCB white connector block, causing intermittant spin on wash.

    Jim.

    August 22, 2007 at 10:43 pm #225476
    Simon46
    Participant

    Re: Hotpoint 9525 pecker

    Will have to dig thru scrap to see if i still have one housing. Cable is different i think?


    Ta Jim

    S.

    August 22, 2007 at 11:00 pm #225477
    iadom
    Moderator

    Re: Hotpoint 9525 pecker

    Yep, cable is a 1601696.

    Jim.

    August 25, 2007 at 12:20 am #225478
    atech
    Participant

    Re: Hotpoint 9525 pecker

    Some old hotpoints had a problem with the module! Is the module mounted on the back of the timer? If so it needs to be changed. It’s about 3″x3″? This caused the motor to go onto a spin, out of sequence.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.