- This topic has 3 replies, 2 voices, and was last updated 18 years, 7 months ago by
.
-
Posts
-
Machine won’t start at all – Prewash light flashing
Run test program, everything works except fill to check leaks.
Ne ideas?Re: beko 1715
when i say prewash i dont mean button perwash indicating child lock i mean the prewash light on the right hand side
Re: beko 1715
Fault codes as follows:
- H1 : NTC OPEN CIRCUIT OR SHORT CIRCUIT ( 10000 )
H2 : HEATER OPEN CIRCUIT ( 01000 )
H3 : HEATER ALWAYS ON ( 11000 )
H4 : VALVE TRIAC SHORT CIRCUIT ( 00100 )
H5 : PUMP OPEN CIRCUIT ( 10100 )
H6 : MOTOR TRIAC SHORT CIRCUIT ( 01100 )
H7 : PRESSURE SENSOR FAILURE ( 11100 )
H11 : MOTOR / TACHO OPEN CIRCUIT ( 00110 )Where “1” is the LED on and “0” is the LED off.
The test sequence is in the fault code guide.
HTH
K.
Re: beko 1715
tried the reset and now works fine.
Prewash flashing is time out on pump which once i tried the reset and ran a drain program, i realised it was slow. Took off outlet and a button was blocking the flow.
Cheers
If the Prewash aux button (left hand side) flashes then its child lock if its the prewash (right hand side) flashing its time out on drain!
- You must be logged in to reply to this topic.