SMEG Model DWI612C problem

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › SMEG Model DWI612C problem

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • August 26, 2007 at 11:12 am #30063
    TimmyT
    Participant

    Can some one help me with a problem with my Smeg dishwasher?

    Its an intergrated model DWI612C about 2-3 years old but the troubleshooting instructions in the manual do not cover the combination of LED lights that are on.

    In this model there are 5 LED’s, with a spray symbol on the far left and a pot symbol on the far right. The far left ‘spray’ LED is permanently on, and the far right ‘pot’ symbol is flashing.

    I can’t change the program and the dishwasher beeps when I try to close the door and does not start the program.

    I’ve cleaned the filter and checked the salt but these are both ok. The closest fault I can find is the ‘E1’ fault but this has the flashing and lit LED’s reversed.

    thanks

    August 26, 2007 at 11:30 am #225736
    clivejameson
    Participant

    Re: SMEG Model DWI612C problem

    That fault indication means it’s registered a leak…ie water in the undertray.

    Drain the floor pan (tip back at 45o with towels down) then run it to find the leak.

    Power off at all times of course :zap:

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.