Belling IDW 603

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Belling IDW 603

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 22, 2007 at 12:52 pm #30745
    MDE
    Participant

    Tracks blown on board, D.W.is dead, does anyone know of a particular fault that will cause this to happen.


    any help would be much appreciated,

    Thanks Mark.

    September 23, 2007 at 7:50 pm #228271
    keithwilliams
    Participant

    Re: Belling IDW 603

    all i can say is try to identify the part of the board thats damaged. i.e. if its near the heater relay check it out. and so on. solder it back together if its not too bad, then put a megger on the machine and try to find the fault.
    what might be encouraging is that i’ve soldered up a couple of dishy boards lately and not found any cause and they’re still going yet.
    i’m afraid i’ve no belling specific info though.

    September 23, 2007 at 8:59 pm #228272
    MDE
    Participant

    Thanks a mil for your reply, will have to go back and have a look.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.