- This topic has 2 replies, 3 voices, and was last updated 18 years, 6 months ago by
.
-
Posts
-
I had a fault previously where the detergent dispenser would not trigger open.
I bought and changed the despenser.
On first operation after re-assembly it won’ cycle and gives E2 message.
Next to the detergent tray within the door chamber is a round object with a few wires. This is held in place with the screws and brackets of the dispenser. It fell off during dismantling and I wonder if maybe i replaced it incorrectly.
when I replace it I put the back steel part of the circular device against the inner door panel.
Any help appreciated.
Gerry4
Re: Smeg E2
Hi
With no model number I will have to guess 😉
If you remove the filters and look at the 12 o clock position for a black rubber flap covering a hole.
Remove the flap from its barbed attachment and then continue to clean as far as possible up that covered hole with something like a babies bottle brush and remove any gunge by hand that may appear.
Re assemble and test.Greg
Re: Smeg E2
gerry4 wrote:
when I replace it I put the back steel part of the circular device against the inner door panel.
Gerry4
That’s how it should be…it’s a thermostat and needs to have surface contact with the door inner to ‘feel’ the temperature.
As to the E2 error follow Gegsy’s excellent advice 😉
- You must be logged in to reply to this topic.