- This topic has 4 replies, 3 voices, and was last updated 18 years, 6 months ago by
.
-
Posts
-
Ive managed to locate a second hand Timer/board. Can anyone tell me where I can find details of connector/wire colours to reconect to board as I did not take too much care whilst removing as wasnt expecting to replace to board, was going to scrap machine.
Many Thanks
Dave
Re: Wiring details needed PLEASE for Hotpoint WM64
Hi Thanks for that I understand your point.
However I am a competent person having repaired many appliances in the past.
I have however sketched the colours and positions of the connectors but wanted a second oppinion back up, as the connectors can be replaced in differant positions and I dont wont to blow the replacement board.if you were experienced and competent, youd have written them down as you took them off!
sorry, cant supply that kind of info, cant be responsible for possible injury
Re: Wiring details needed PLEASE for Hotpoint WM64
Hi Helo 75
I did in fact write them down as I said earlier, Although at the time I was intending to scrap the machine.
As I said earlier I just need confirmation that I have scetched the plug type and colours OK as there are duplicate connectors.and its easy to miss match.
Guess Ill just have to trace wires back and go ahead.
Just didnt want to run the risk of blowing the replacement board.
- You must be logged in to reply to this topic.