Indesit WIL103 Auto – fab con not going

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit WIL103 Auto – fab con not going

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 3, 2007 at 5:00 pm #31072
    MickGeorge
    Participant

    Hi folks

    Been to above today and no water into fab compartment.. suspect fab con jet blocked.. tried to unblock without success so looks like a dispenser change but..

    How do they get fab cond to work on thses machines?.. when I saw double cold valve thought it was convetional cold fill + fab con but when I tested valves by swapping connections found one fed the prewash compartment and the other fed the main wash compartment????

    Is it like one of the old Phillips machines where they activated two valves and the water collided into the fab con compartment?

    Other question… anyone changed a dispenser on one of these.. looks like it might be a bit of a pig as part of the covered in dispenser feed goes under the support strap and looks like a bit of a struggle to get out underneath it..

    Thanks

    Mick

    October 3, 2007 at 5:31 pm #229564
    johnnyj
    Participant

    Re: Indesit WIL103 Auto – fab con not going

    I usual unclip top of dispenser from bottom then using a bit off capilary pipe give it a good poke about then flush it out, you need both valves activated to divert water into fab compartment. make sure water press is high enough or it wont dispense also. jj

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.