- This topic has 5 replies, 4 voices, and was last updated 18 years, 6 months ago by
.
-
Posts
-
hi, how do i get into the drain pump 😥 😳 the fault is ..the d/w clock comes on ok,the pump seems to stutter,and a relay seems to be clicking somewhere ❓ ❗ ❗ the d/w will fill, no circulation motor action, and if i manually activate the float switch it will empty. any help,manual etc much appreciated 😉
Re: bosch dishwasher sgs43e02gb/35
Hi
If you can make the dishwasher empty then you do not have a problem with the drain pump 😉
The stuttering is more likely caused by a semi blocked ribbed pipe behind lower plinth, caused by fiid debris/crud build up.
The pipe will pull off as its only “o” ringed in, clean thoroughly and test.
Should be ok then.Greg
Re: bosch dishwasher sgs43e02gb/35
tried all that. there is something clicking, but i cant get to the motor etc 😳 how do you take these things apart ❓
Re: bosch dishwasher sgs43e02gb/35
The clicking is most probably the water diverter on the heater.
It may be jammed but unfortunately comes complete on the heater p/no 483058.Check your email for everthing you will need 😉
Greg
Re: bosch dishwasher sgs43e02gb/35
I agree with Gegsy’s first reply. If the drain pump runs with the anti-flood s/w made, you don’t have a problem with the pump.
You say you’ve checked the sump hose, but have you removed, stripped and cleaned the pressure chamber it connects to ❓ .
Also have you checked the dump valve on the side chamber for continuity, as this m/c splits it’s fill through the dump valve and the pressure system.
As Greg said the other “clicky” bit would be the diverter on the underside of the heater. So worth checking the simple bits first 😉
Re: bosch dishwasher sgs43e02gb/35
I agree with all that’s been said above – But for future reference you can get to check the drain pump from the front of the machine. It’s positioned on the left hand side of the base – just remove the screw holding the cover over the pump and you can see the impellor & then check for any blockages. 😉
Brian.
- You must be logged in to reply to this topic.