- This topic has 2 replies, 2 voices, and was last updated 18 years, 6 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
Hi
Prima dishwasher (which I believe is whirlpool) customer complained of it stopping on prog. Reset the prog and all I get is a constant beeping from the control and the rinse light stays on. Checked heater, valves, no water in base, drain pump ok.
Any ideas ? Thanks.Re: Prima Dishwasher
If Whirlpool check the NTC – little finger like probe in the centre of the base 😉
If that’s ok count the beeps and check the number against the “known error codes” link above. Another common fault on w/p’ d/w is the black grid like component to the right of the base with three connections. unscrew it clean it and retry – do not penetrate the membrane!
Brian.
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.