Adjusting Simmer

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Adjusting Simmer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 18, 2007 at 3:25 pm #31480
    bytesback
    Participant

    Hi,

    We have just had Calor gas put in the house for cooking. No problems with the gas installation. We bought a Statesman G501 cooker and had a Corgi bloke round to do the conversion.

    However, the simmer is to high. In the manual it says you can take the knob off and adjust the simmer through the hole in the centre spindle. Ok, how ?

    Also, is this something I should be doing ? I really don’t want to have to pay a ridiculous call out charge just to adjust it.

    October 18, 2007 at 6:07 pm #231289
    Tom
    Participant

    Re: Adjusting Simmer

    This should have been done as part of the Corgi installation. You might not have to pay if you let them know that it still needs to be done.
    tom

    October 19, 2007 at 12:37 am #231290
    wsts
    Participant

    Re: Adjusting Simmer

    Tom wrote:This should have been done as part of the Corgi installation. You might not have to pay if you let them know that it still needs to be done.
    tom

    Correct, if he hasnt done it he hasnt converted your cooker properly, I go to quite a few where it hasnt been done by the installer.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.