- This topic has 7 replies, 5 voices, and was last updated 18 years, 5 months ago by
.
-
Posts
-
can any one out there help me, i need the wiring diagram for a bosch t/drier. model WTA3003GB/01. S/n FD8311011874. it looks as if is the same as the white knight model.
customer has had a go himself, putting a belt on, and has pulled the wires off at the back. m/c now runs with door open.
thanks TELL..Re: HELP, a customer has done it again, i need a wiring diag
from a white knight…had same conditions after customer had changed the heater..runs with door open..i found he had put one of the wires from the t/stat onto the mains block instead of the second tag on the heater, extreme right, looking from the top at the rear, its the tag with a wire going to the timer..hope this helps.
richardRe: HELP, a customer has done it again, i need a wiring diag
Previous post from P45 lists the connector block wiring here.
http://www.ukwhitegoods.co.uk/modules.p … ht=wta2000
John
Re: HELP, a customer has done it again, i need a wiring diag
A picture saves a thousand words…….. 😉
Re: HELP, a customer has done it again, i need a wiring diag
And just how many times have i pulled those wires off and forgotten where they refit???? (i end up spending time working out the circuit with my meter just to finish the job) 😆 😆 😆
Re: HELP, a customer has done it again, i need a wiring diag
clive, take a photo with your phone or digital camera.you then have thr picture forever. 😉
richard
ps or print the one above.. 8)
rRe: HELP, a customer has done it again, i need a wiring diag
I have already done so 😆
I think i have about twenty pics on my phone and they’re all of Crosslee heater connections….or Bosch DW element connections. I must get a mental block with these two, i rarely make a diagram for these simple jobs.
The problem usually happens when the good-loooking housewife smiles and says ‘one lump or two’ just when you’re half-way through 😉 😆
Re: HELP, a customer has done it again, i need a wiring diag
i think that should help me. it looks like he has put the black and white wire onto the live, aswell as not linking it with the N from either the stat, or heater onto its own terminal.P.S. I’m trying to copy my photo on to this page, but now your asking something now!!!!.
TELL..
- You must be logged in to reply to this topic.