Hotpoint BF41 dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BF41 dishwasher

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 12, 2007 at 6:54 pm #32132
    goosegreen
    Participant

    Would any one have an exploded diagram for the above? The problem is the molded hub which the lower spray arm is attached to is very loose in the tube it fits into. Should there be anything under the molded hub or does it just sit in the tube?

    Thanks in advance


    Goose

    November 12, 2007 at 7:05 pm #233728
    Martin
    Participant

    Re: Hotpoint BF41 dishwasher

    Hey Goose!

    All that is below the bottom spray arm is (in order) 😉

    1801546 ‘Milled Bush’
    1801541 ‘Moulded Hub’

    HTH?

    November 12, 2007 at 7:23 pm #233729
    goosegreen
    Participant

    Re: Hotpoint BF41 dishwasher

    Ta, For that Martin, The Milled Bush is missing but the Masterpart pic shows that the molded hub comes with this bush. £16 squid + for 2 small bit of plastic :cry:.


    Goose

    November 12, 2007 at 7:31 pm #233730
    EFS
    Participant

    Re: Hotpoint BF41 dishwasher

    Try the Brandt version available from Connect 😈
    Ref:5031686089084 less than half the price.

    Steve

    November 12, 2007 at 8:19 pm #233731
    goosegreen
    Participant

    Re: Hotpoint BF41 dishwasher

    Thanks for that EFS, Got an order running with M/P and as the spray arm is cheaper might as Well go with them as it will P&P free, Your right though I have saved loads going for the Brandt version of the parts in the past Especially on the door hinge kit for this model. HP list hinges up to £68 squid each, But Brandt / Fagor do a complete kit for £30 odd (32X0611).


    Goose

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.