Fisher & Paykel double dishdrawer 601 v2 overfilling

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel double dishdrawer 601 v2 overfilling

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 23, 2007 at 11:00 pm #32470
    Cylon
    Participant

    I Can transfer fault to either draw by changing the controller,
    this gives u3 as well, because its not able to empty in the time available. if you cut of the water supply b4 fault code comes up its works fine

    Does anyone have data on how to set it for low or high pressure, water suppply, I read elsewhere this could be the cause.
    and water temp as well, this takes longer that it should to heat up, about 10 mins longer than the other draw, although it does heat up and run ok.
    apparently its some special button combination to enter adjustment mode ???, all these problems are on one controller only, so i guess i have eliminated everything else by a change around

    Puzzled tech

    November 24, 2007 at 9:07 am #235251
    Cylon
    Participant

    Re: Fisher & Paykel double dishdrawer 601 v2 overfillin

    Lots of button pushing later like cracking a safe, must be more in their but this will do for now I got it fixed, one controller was set to lp the other hp.
    who did this we will never know, but both at hp and its all ok.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.