Zanussi ZT 685 Rinse Hold light flashing.

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Zanussi ZT 685 Rinse Hold light flashing.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 24, 2007 at 11:13 pm #32488
    arthur2
    Participant

    When the dishwasher in turned on to any programme ,it will run for anything from 5 – 15 minutes then stops.The rinse hold button (furthest left) is then found to be flashing rapidly.It can be re-started but nearly always does the same again.It will complete its full cycle once in around ten attempts. 🙁

    November 25, 2007 at 12:59 am #235317
    Penguin45
    Participant

    Re: Zanussi ZT 685 Rinse Hold light flashing.

    It thinks it’s still full of water. The problem will be the IWMS or fill matrix under the left hand side panel. If you remove that panel, you will probably find that the lower portions are coloured black, indicating the presence of food detritus, choking the tubes.

    The only proper solution is to replace the IWMS. Part number 1524624-03/6, spares@ukwhitegoods.co.uk will be able to get one for you.

    Power off, if you intend to investigate this youself.

    Penguin45.

    November 25, 2007 at 5:06 am #235318
    arthur2
    Participant

    Re: Zanussi ZT 685 Rinse Hold light flashing.

    Thanks ,will have a look.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.