- This topic has 7 replies, 4 voices, and was last updated 18 years, 4 months ago by
.
-
Posts
-
Hi Guys
I hope you can help me with this one. I am getting 1&3 lights flashing counting from the top, they are the mini load and rinse hold lights.
What happens is you can put it on a wash it will fill up with water and start the wash then it aborts and empties, it is ok on the spin I have tried a replacement pcb from emw and tested the heater and ntc and tightened the edge connecters.Can you help
monkeyRe: hotpoint wf220 pressure fault
Pressure switch not working? Or filling to flood protection?
Chris.
Re: hotpoint wf220 pressure fault
Hi
I went back out to the appliance to try a pressure switch on which I ordered part no. 1604875 which would not fit.So while I was there I disconnected the small black on the pressure switch and the machine worked ok.So it is going into flood protection I guess the pressure switch is faulty unless you have any other suggestions.Do you have the correct part no. for the pressure switch.
monkeyRe: hotpoint wf220 pressure fault
I found if I disconnected the black wire on the pressue switch it works ok so it must be going into flood protection. But I cant get the correct pressure switch.
monkeyRe: hotpoint wf220 pressure fault
Always a possibility that the wrong switch was in the bag, not the first time that has happened. That is the only part shown for that model. Can you find the commercial code from the rating plate.
Jim.
Re: hotpoint wf220 pressure fault
Sometimes the sw’s that you get the terminal orientation is differant and the plug has to turned 180′ . jj
- You must be logged in to reply to this topic.