aeg oven

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › aeg oven

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • December 9, 2007 at 10:22 pm #32876
    fasetester
    Participant

    hi guys have to check out a aeg oven the problum was that the oven cut out after it had been on for a time. then when it cooled down would come back on again. but now it wont heat could this still be the over heat stat that is stopping the oven from heating. 🙂 thanks fasetester

    December 10, 2007 at 12:06 am #236690
    Penguin45
    Participant

    Re: aeg oven

    If it’s a proper Lux-built AEG (model numbers are very helpful), this little blighter has cause endemic problems:
    http://shop.ukwhitegoods.co.uk/product_ … cts_id=349

    Penguin45.

    December 10, 2007 at 6:39 pm #236691
    fasetester
    Participant

    Re: aeg oven

    thanks chris for your reply when the over heat stat is shorted out the fan should run and the oven heat is there any other stats that would stop the oven working. thanks fasetester.

    December 11, 2007 at 12:39 am #236692
    Penguin45
    Participant

    Re: aeg oven

    Fase,
    You’re going to have to come up with a model number or a Pnc – that was a “best guess”. That sensor is not a conventional thermostat.

    Chris.

    December 12, 2007 at 10:56 pm #236693
    fasetester
    Participant

    Re: aeg oven

    the model isB4100-1-w have checked it out needs new over heat stat plus fan oven element thanks chris fasetester 🙂

    December 17, 2007 at 2:38 pm #236694
    fasetester
    Participant

    Re: aeg oven

    hi guys could any one tel me is the element for this oven fixed by studs and nuts. or is the fixing plate screws and bolt or does it matter as there are 2 elements with different fixings. but the same size only difference one is studs and the other is not. thanks fasetester 😕

    December 17, 2007 at 10:31 pm #236695
    fasetester
    Participant

    Re: aeg oven

    hi chris would you know if either will do i dont want to go with the wrong element thanks fase .

    December 17, 2007 at 10:41 pm #236696
    roly16
    Participant

    Re: aeg oven

    If you take the one with the studs like the neff elements and it’s wrong you you can always work them loose, take them out and use self tapping screws instead. I do that all the time with the neff ones.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.