- This topic has 4 replies, 4 voices, and was last updated 18 years, 3 months ago by
.
-
Posts
-
The above machine fills to the correct level then washes as normal. After about 10 minutes it starts to fill again eventually bringing up the slow/overfill error.
I have checked the pressure chamber & the pressure switch hose but can’t find any problems.
I haven’t been able to get the machine to do this when I’m there but the customer says this is happening.
Any suggestions would be appreciated.
Re: Hotpoint WMA30P Overfills after 10 Mins
Check the air pressure hose for small cracks or if it has been rubbing anywhere. Failing that you can only change the pressure switch itself.
HTH
Sean
Re: Hotpoint WMA30P Overfills after 10 Mins
I am sure i once had a blocked sump hose cause this fault.
Re: Hotpoint WMA30P Overfills after 10 Mins
When checking the pressure chamber I had the sump hose off and filter out which eliminates that as a possibility.
Re: Hotpoint WMA30P Overfills after 10 Mins
Twoten wrote:When checking the pressure chamber I had the sump hose off and filter out which eliminates that as a possibility.
Not necessarily as it’s best advised to take the air chamber right off the sump hose, clean it and replace that pressure hose. The hoses do chaff against the moulded tub retainers after all. 😉
- You must be logged in to reply to this topic.