- This topic has 8 replies, 2 voices, and was last updated 18 years, 3 months ago by
.
-
Posts
-
HEllo went to a machine that pumps then fills but at the end of the fill where its supposed to pump water around machine it makes clicking sounds, 2 clicks on the circuit board and then a louder click at the back of the machine from a little box near the water inlet panel
Ne ideas?
Re: Miele G1270 f14
Heater relay but usually pressure switch then drops out saying not enough pressure from circ pump. 80-90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time its the pressure switch playing up the rest usually blocked circ pump and on the odd ocasion the circ pump itself.Nice easy little job hope this helps
philfish
Re: Miele G1270 f14
so where is the pressure switch on the machine, when i went there the only thing i could get to was the pump from inspection panel, do u take bottom off?
Re: Miele G1270 f14
Take left hand side panel off(take lid off 2screws on top 3 screws on front 1 screw on rear might need to take kick panel aswell) its usually right by the circ pump if i remember its just a push fit type connector oval shape.
Re: Miele G1270 f14
i just read on another post that u say if pump doesnt kick in then its on motor, the one i went too fills and then u just get a clicking noice no motor kicks in at all
Re: Miele G1270 f14
oh sorry in that case check the circ pump aswell they right by each other but you will need to get the base off to get circ pump out
- You must be logged in to reply to this topic.