Indesit IDL705 lights 2+3 flashing

Home Forums Public Support Forums Help And Support Dishwasher Help Forum Indesit IDL705 lights 2+3 flashing

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • #33421
    trigat
    Participant

    Hi i have a problem with my Indesit IDL705 dishwasher, when i switch the thing on the 1st light comes on as per normal it then waits about 60 secs beeps 4 times and then does nothing. i then pressed the reset button and lights 2 and 3 start to flash.

    Any help is appreciated.
    Mark

    #238563
    Penguin45
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    No fill. Check water is on, fill hose not trapped or kinked. Valve failure also possible.

    Power off if you need to remove any panel.

    Penguin45.

    #238564
    trigat
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    Hi just checked there is mains supply to the dishwasher, is the valve the one with the little orange plug right next to the inlet pipe?

    #238565
    Penguin45
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    Correct. Coil should read about 3.5kOhms.

    Penguin45.

    #238566
    trigat
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    Its reading 3.97kohms is this still ok

    #238567
    Penguin45
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    Yup, that’ll do – there is a fair bit of variation. Most likely PCB at fault in that case – not turning the valve on.

    Penguin45.

    #238568
    trigat
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    That was it i must have knocked the main cable connecting to the pcb when i replaced the on/off switch, now working fine thanks Penguin45

    #238569
    Penguin45
    Participant

    Re: Indesit IDL705 lights 2+3 flashing

    You didn’t tell me you’d already been in it………

    :p45:

Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.