- This topic has 2 replies, 2 voices, and was last updated 18 years, 3 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
been here today but cant get back legs raised.i dont do much with dishwashers but i know the adjustment screw at front is usually about 7mm to do back legs but this one is tiny any body know the size going back with drain pump on thurs.
cheers chris.
Re: teka d/washer
Hi Chris
A 4mm socket will do the job 8) 😀
Oh, as for drain pump, r/h panel off and just remove the three torx holding main pump body onto housing is easier than trying to get at the one screw on housing, stupid angle 😡
Greg
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.