Zanussi WJS1265W E10 and dryer not working.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi WJS1265W E10 and dryer not working.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 15, 2008 at 4:11 pm #33712
    Simon46
    Participant

    Cust reported no drain and dryer not working. Went to his one found showing E90 when buttons pressed in on facia. Cleaned adjusted ribbon cable contacts. Filter badly gunged up. Cleaned.
    Cust rings today E10 noted and dryer not working, washer ok. Would this be a solenoid inlet valve O/C no fill or a condensor blockage no drain?
    Did notice that tumble begins when dryer set but no fill or fan operation starts when left on a few minutes. Im sure it takes a while to start IIRC. anyway.

    Regards
    Simon

    January 15, 2008 at 4:16 pm #239740
    Martin
    Participant

    Re: WJS1265W E10 and dryer not working.

    E10 usually means that the triple valve is faulty. 😉

    January 15, 2008 at 4:17 pm #239741
    Simon46
    Participant

    Re: Zanussi WJS1265W E10 and dryer not working.

    Thanks Martin.

    S.

    January 15, 2008 at 5:30 pm #239742
    Simon46
    Participant

    Re: Zanussi WJS1265W E10 and dryer not working.

    Yep green solenoid O/C. Valve on order. Thanks once again. 😀

    Regards
    Simon

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.