HOTPOINT WASHER WF541

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › HOTPOINT WASHER WF541

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 17, 2008 at 8:42 pm #33789
    winker
    Participant

    Machine starts to fill on a wash cycle and then defaults to pump out and the on/off neon flashes rapidly together with slow flashes on the rinse hold and mini load neons.Anyone with ideas.motor action appears ok

    January 17, 2008 at 8:43 pm #240059
    Penguin45
    Participant

    Re: HOTPOINT WASHER WF541

    L-R, 1-4, which neons?

    Chris.

    January 17, 2008 at 8:54 pm #240060
    winker
    Participant

    Re: HOTPOINT WASHER WF541

    these run top to bottom 1-5,only identified functions not position…..plank

    January 17, 2008 at 9:02 pm #240061
    winker
    Participant

    Re: HOTPOINT WASHER WF541

    Good ole’ Hotpoint download a instruction book.

    So the neons top to bottom are three and four which flash slowly and the on/off which flashes rapidly

    January 17, 2008 at 9:07 pm #240062
    winker
    Participant

    Re: HOTPOINT WASHER WF541

    looks like F03 NTC,do you agree.What would the value of this be at room temp

    January 17, 2008 at 9:35 pm #240063
    helo_75
    Participant

    i wouldnt concern yourself with that, its probably the board anyway

    January 17, 2008 at 11:03 pm #240064
    lerch
    Participant

    Re: HOTPOINT WASHER WF541

    Fault list is pcb / ntc short. Check heater should be around 28-30 resist. If you get that reading try changing ntc first which is cheaper opition to pcb. 🙂

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.